Jobo Tecnolab 80 Delta Pro programmable E-6 dip and dunk processor in excellent condition. Everything works perfectly and I will offer a 30 day warrantee on all the parts and components of the processor, in writing. This processor has 18 months of low volume use on it. It came from a production house that did all of their own E-6 processing. Although this model has been officially discontinued and replaced by the MICRO (approx. 35,000.00USD new) it is currently supported by Jobo USA as well as the factory in Italy. I have confirmation of this. ALL replacement parts are still available and there is NO plan to discontinue supplying any parts from the factory or from Jobo USA. It is a 1997 model that was put into service in 1998 and taken out of service in late 1999. It was professionally serviced and dismantled by a Jobo trained service technician. I have a signed letter from the lab it came from to verify this. ALL fluids have been removed and flushed. I am standing behind this product, because I know it was well cared for and has had little use. This is a medium volume processor that has the smaller 60 liter tanks, as opposed to the larger 90 liter tanks of many of the other units out on the used market right now. Hookup for voltage is either 220V North American single phase or 220 or 380 three phase. This is a 60 cycle model. (North American voltage) Hangers included are as follows: 3-35mm,4-120,2-220,5-4X5" and 5-8X10" hangers. New hangers are available directly from Jobo USA. The full operator and installation manual is included. It will process up to 100 E-6 films per hour and includes the dryer an replenishment module. The photos you see were taken after is was removed from service. You will not find a model in better condition and with less use anywhere.

| contact us | return to home